Recommended products

Deconta Automatic+

A concentrated product for professional laundering of turnout gear and machine washing of PPE (masks, helmets, breathing-apparatus harnesses).

Properties in the wash solution

  • Non-ionic: does not bind to the water-repellent finish or the membrane
  • High stability in acidic and alkaline conditions, including hard water
  • Low foaming, especially at higher temperatures, suitable for professional washing machines and washers
  • Strong detergency, emulsification and dispersion, especially in alkaline and neutral conditions
  • Enhanced degreasing thanks to a non-halogenated solvent
  • No affinity to textile fibres, rinses out easily without residue
  • Compatible with most common detergents and additives
  • Material compatibility: a 5% solution after 48 hours did not affect aluminium, polyacrylate, EPDM, brass or V2A stainless steel, parts of the Panorama Nova mask or the straps of a Dräger breathing apparatus

Why it matters: the textile stays clean without detergent residue and keeps the breathability and softness of the membrane and aramid fibres. This is important in professional laundering, where gear is tested for residual contamination and functional properties.

Laundering turnout gear

  1. Spray heavily soiled gear on the outer side with the product diluted 1 : 10, let it work for a while and rinse from top to bottom. Keep the coat closed.
  2. 1st cycle, outer side out: 25–50 ml directly onto the garment per piece (jacket or trousers) depending on soiling.
  3. 2nd cycle, inside out: again 25–50 ml per piece, the same programme according to the garment manufacturer.
  4. Temperature 40 °C for normal, 60 °C for heavy soiling, only if the garment manufacturer allows it. Rinse and spin at the maximum permitted speed.

Manufacturer's tip: for extremely soiled gear, add 15–20 g of sodium carbonate to stage 1. The pH of the wash water should not exceed 9.5.

Washing masks, helmets and harnesses in a washer

  1. Disassemble according to the manufacturer (exhalation valve on masks, electronics on helmets, cylinder and demand valve on harnesses) and put the parts straight into the washer.
  2. Dosing: 20–30 ml into the washer's dispenser depending on soiling. Programme according to the type of equipment, usually up to 60 °C.
  3. After washing touch up and rinse with clean water only where necessary, especially the inside of masks and the helmet textiles. Dry without direct heat, then do a function test.

The product is concentrated. At higher doses a white film may appear on the equipment.